CHZKD - 88 6 LATEX SEMI GLOSS WHITE & PASTEL BASE

  • MSDS: CHZKD
  • Manufacturer: PPG INDUSTRIES INC
  • Product Name: 88 6 LATEX SEMI GLOSS WHITE & PASTEL BASE
  • National Stock Number: 8010-00F018029
Product Identification

Product ID:88 6 LATEX SEMI GLOSS WHITE & PASTEL BASE
MSDS Date:03/19/1997
FSC:8010
NIIN:00F018029
Status Code:A
MSDS Number: CHZKD

Responsible Party
PPG INDUSTRIES INC
1 PPG PL
PITTSBURGH, PA 15272-0001
US

Emergency Phone: 412-434-3131

Info Phone: 412-434-3131

Cage: 47695

Contractor
PPG INDUSTRIES INC
PITTSBURGH, PA 15272 US

Telephone: 1-800-245-2974 (CAL HYPO)

Cage: 47695

Ingredients

TITANIUM DIOXIDE, TITANIUM OXIDE (SUSPECTED ANIMAL

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 10-<20%

OSHA PEL 15 MG/CUM

ACGIH TLV: 10 MG/CUM (DUST)


HYDRATED ALUMINA, ALUMINUM HYDROXIDE, ALUMINUM OXIDE

CAS: 21645-51-2

RTECS: BD0940000

Fraction By Weight: 1-<5%

OSHA PEL 15 MG/CUM (DUST)

ACGIH TLV: 2 MG/CUM (DUST)


AMORPHOUS SILICA GEL, SILICON DIOXIDE *98-3*

CAS: 7631-86-9

Fraction By Weight: 1-<5%

Hazards

Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:HARMFUL IF INHALED/SWALLOWED.
EYES/SKIN: MAY CAUSE IRRITATION.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION

First Aid

First Aid:INGESTION: GIVE 1-8 OUNCE GLASSES OF WATER. DON'T INDUCE
VOMITING. GENTLY WIPE OUT INSIDE MOUTH TO REMOVE ANY RESIDUAL
MATERIAL. EYES: FLUSH IMMEDIATELY W/A GENTLE STREAM OF LUKE WARM
WATER FOR 15 MIN S. SKIN: FLUSH IMMEDIATELY W/PLENTY OF WATER FOR
15 MINS FOLLOWED BY WASHING W/SOAP & WATER. INHALATION: REMOVE TO
FRESH AIR. GIVE CPR IF NEEDED. OBTAIN MEDICAL ATTENTION IN ALL
CASES.

Fire Fighting

Extinguishing Media:USE EXTINGUISHERS APPROPRIATE FOR SURROUNDING FIRE.
Fire Fighting Procedures:WATER SPRAY MAY BE INEFFECTIVE, BUT MAY BE
USED TO COOL CLOSED CONTAINERS EXPOSED TO EXTREME HEAT. IF WATER IS
USED, FOG NOZZLES ARE PREFERRED. USE SCBA.
Unusual Fire/Explosion Hazard:KEEP AWAY FROM HOT SURFACES & OTHER
IGNITION SOURCES. VAPORS TRAVEL TO AN IGNITION SOURCE & FLASHBACK.
CLOSED CONTAINERS MAY EXPLODE WHEN OVERHEATED.

Accidental Release

Spill Release Procedures:PROVIDE VENTILATION. ONLY PERSONNEL EQUIPPED
W/PROPER PROTECTED EQUIPMENT SHOULD BE PERMITTED IN THE AREA.
REMOVE ALL SOURCES OF IGNITION. TAKE UP MATERIAL
W/SAND/VERMICULITE/NONCOMBUSTIBLE ABSORBENT. PLACE IN CLEAN EMPTY
CONTAINERS FOR DISPOSAL.

Handling

Handling and Storage Precautions:DON'T STORE >120F. KEEP FROM IGNITION
SOURCES, KEEP CONTAINERS TIGHTLY CLOSED WHEN NOT IN USE. CONTAINERS
SHOULD BE GROUNDED WHEN POURING.
Other Precautions:MATERIAL IS PART OF MULTIPLE COMPONENT SYSTEM, READ
MATERIAL SAFETY DATA SHEETS FOR OTHER COMPONENT/COMPONENTS BEFORE
BLENDING, THE RESULTING MIXTURE MAY HAVE THE HAZARDS OF ALL PARTS.
AVOID FREE FALL IN EXCESS OF A FEW INCHES.

Exposure Controls

Respiratory Protection:WHERE VENTILATION IS INADEQUATE, USE A NIOSH
APPROVED AIR PURIFYING RESPIRATOR W/THE APPROPRIATE CHEMICAL
CARTRIDGES/POSITIVE PRESSURE, AIR SUPPLIED RESPIRATOR.
Ventilation:GENERAL DILUTION/LOCAL EXHAUST VENTILATION TO KEEP
CONCENTRATIONS TO LOWEST EXPOSURE LIMITS, LEL BELOW STATED LIMITS.
Protective Gloves:IMPERVIOUS
Eye Protection:SAFETY GLASSES
Work Hygienic Practices:REMOVE/CLEAN CONTAMINATED CLOTHING & SHOES.
Supplemental Safety and Health
VAPORS MAY COLLECT IN LOW AREAS.

Chemical Properties

Boiling Pt:B.P. Text:212-475F
Vapor Pres:17.3
Vapor Density:>1
Spec Gravity:1.192
Evaporation Rate & Reference:(BUOAC=100): 34
Solubility in Water:69.3%
Appearance and Odor:VISCOUS LIQUID W/AN ODOR CHARACTERISTIC OF THE
SOLVENTS.
Percent Volatiles by Volume:71.26

Stability

Stability Indicator/Materials to Avoid:YES
STRONG ALKALIES, STRONG MINERAL ACIDS/STRONG OXIDIZING AGENTS
Stability Condition to Avoid:EXTREME HEAT, FLAME CUTTING, BRAZING,
WELDING.
Hazardous Decomposition Products:OXIDES OF ALUMINUM, CO, CO2, LOWER
MOLECULAR WEIGHT POLYMER FRACTIONS

Disposal

Waste Disposal Methods:EMPTY CONTAINERS SHOULD BE RECYCLED/DISPOSED OF
THROUGH AN APPROVED WASTE MANAGEMENT FACILITY. DISPOSE OF
IAW/LOCAL, STATE & FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.